Differences

This shows you the differences between two versions of the page.

--- documents:mtb-etc:form_mtb-etc_ioi_10-22 [2022/11/08 12:25]
slandreth [9.0 TRANSDUCER TABLE]
+++ documents:mtb-etc:form_mtb-etc_ioi_10-22 [2022/12/05 11:37] (current)
slandreth [MTB-etc Installation and Operating Instructions]
@@ Line 1: / Line 1: @@
-=======Installation Instructions=======
+=======MTB-etc Installation and Operating Instructions=======
+{{ :documents:mtb-etc:mobius Terminal Board 6.jpg?nolink |}}
+======Installation Instructions======
 ====1.0 DESCRIPTION====
@@ Line 135: / Line 163: @@
 ===4.2 SENSOR WIRING DISCRETE INPUTS===
 The sensor leads connect to the removable terminal strips on the terminal
-board. Any discrete sensor point can be wired for normally-open or normallyclosed
+board. Any discrete sensor point can be wired for normally-open or normally-closed
 operation.
@@ Line 625: / Line 653: @@
 FIGURE 4 — WIRING DIAGRAM — DIGITAL OUTPUT SWITCHES
-===FIGURE 1 — MODBUS TERMINAL BOARD===
-{{ :documents:mtb-etc:mtbetc_fig1.png?nolink |}}
-===FIGURE 2 — WIRING DIAGRAM — SENSOR AND TRANSDUCER INPUTS/POWER===
+{{ :documents:mtb-etc:fig1.jpg?nolink |}}
-{{ :documents:mtb-etc:mtbetc_fig2.png?nolink |}}
+{{ :documents:mtb-etc:fig2.jpg?nolink |}}
+{{ :documents:mtb-etc:fig3.jpg?nolink |}}
+{{ :documents:mtb-etc:fig4.jpg?nolink |}}
-===FIGURE 3 — WIRING DIAGRAM — CURRENT LOOP OUTPUTS===
-{{ :documents:mtb-etc:mtbetc_fig3.png?nolink |}}
-===FIGURE 4 — WIRING DIAGRAM — DIGITAL OUTPUT SWITCHES===
-{{ :documents:mtb-etc:mtbetc_fig4.png?nolink |}}