Differences

This shows you the differences between two versions of the page.

--- documents:afr-500:afr500operating [2022/04/04 22:11]
rocky [13. PRE-START INSTALLATION CHECKLIST]
+++ documents:afr-500:afr500operating [2023/03/09 11:22] (current)
rocky [13. THERMOCOUPLE ALARMS]
@@ Line 2: / Line 2: @@
 ===== - SYSTEM DESCRIPTION =====
------ Better picture of product to get to chuck
+{{ :documents:afr-500:rocky_pix.jpg?nolink&1000 |}}
 ==== - OVERVIEW ====
@@ Line 55: / Line 55: @@
 </html>
-[[documents:awi:awi_connection|{{:documents:afr-500:terminal_builder.jpg?nolink&600|}}]]
+[[documents:awi:awi_connection|{{:documents:afr-500:terminal_builder.jpg?nolink&600|}}]]\\
+\\
+\\
+\\
+**Single bank display configuration:**
+{{:documents:afr-500:acm_single_bank.jpg?nolink&800|SINGLE BANK CONFIGURATION}}\\
+\\
+\\
+\\
+**Dual bank display configuration**\\
+{{:documents:afr-500:acm_dual_bank.jpg?nolink&800|}}
@@ Line 471: / Line 482: @@
 {{:documents:afr-500:img_7961.jpeg?nolink&200|}}
-Jumper GND - DI3 = Auxiliary Mode
+Jumper +5V - AD3 = Auxiliary Mode
 Auxiliary Mode is indicated by a BLUE LED located below the Altronic P/N on the label
 {{:documents:afr-500:img_7965.jpeg?nolink&200|}}\\
@@ Line 532: / Line 543: @@
   * Non-latching registers that when mapped to the AWI appear as an LED and turn off after the fault condition has cleared
   * Latching registers that when mapped to the AWI will appear as an LED and stay on even after the thermocouple is no longer in the fault condition
-  * A digital output signal attached to Digital Output 1 that latches on a fault condition
+  * A digital output signal attached to LS Digital Output 1 that latches on a fault condition
 To clear all of the alarms, regardless of a single or dual bank system, there is one ALARM ACKNOWLEDGE register.